|
01 February
2010:
I began manufacturing the seats. I took
suitable pieces from my parts box. For the front seat, I used half round
strips for the seat pattern. The photo shows the first one glued in place.
I made the bottom part for the rear seat from styrene sheet.
|
|
02 February
2010:
I continued the pattern for the front seat
and added a thickening part at its rear. I filled the bottom and back sides
of the rear seat with polyester putty, and added a rounding part at the
very top. I began making the seat pattern the same way as the front seats.
|
|
05 February
2010:
For the shift lever boot, I made a mold.
I used a headed pin for the lever, and made the boot by melting E-Z Water
(from Micro-Mark) in the mold. To provide easy entry for the pin, I inserted
a pin from the backside of the mold so the boot would be cast with a hole
inside. The lever and boot assembly is shown inserted to the left of the
boot mold.
|
|
06 February
2010:
For the steering wheel shaft and the signal
switch, I made a master from balsa and wires, then made a 2-piece mold.
For production, I located the wires in the mold, then applied marble glue
at the center and closed the molds. The molded part is shown at the very
right, nearby the master.
|
|
07 February
2010:
For the steering wheel, I made a master
from wire and made a 2-piece silicone mold. In the middle photo, the female
and male molds and the raw output is shown. At the rightmost is the steering
wheel with rough cleaning of the flashings.
|
|
For the front bumper, I shaped
an old cutter to the bumper profile and scraped a plastic strip over and
over till I reached the normal profile.
|
| Then I shaped the bumper by heating,
sanded the ends, made the bumper horns from plastic and glued them on the
bumper. I made the bumper brackets from wire and fixed them with CA glue.
I will make a mold from this master.
|
|
25 February
2010:
For the windshield and rear glass parts
from acetate, I made a male mold from galvanized steel sheet and fixed
it on a Lego block. I held the acetate sheet between two frames and heated
vith a heat gun. After softening, I pressed the assembly over the mold
and shaped the acetate sheet.
|
|
At the left is the formed acetate
sheet, at the right is the trimmed part.
|
04 March
2010:
To check the assembly steps, I began
to build the model of my Anadol that I once owned. The chassis is done
as below:
|
|
I painted the body as by then.
I installed the inner side panels, the dashboard and the glasses.
|
|
A look at the dashboard from outside
|
|
The seats had covers made from
sheep hide. I used some dustcloth and covered the seats to depict the original.
|
24 March
2010:
Photos of the finished model. The red
band needs some retouch.
 
|
 
|
 
|
 
|
| |
| |
 ......
|
