| First I dismantled
the whole apart... |
|
| I filed and sanded
the mold parting lines. |
|
| I sanded down the
flange-like contour around the boot. |
|
| Now the boot has smooth
and correct contour. |
|
| The front part also
needed good care for sanding down the parting lines, they were in
delicate
places. |
|
| I stripped the paint
with an automotive paint remover. |
|
| Body in the white... |
|
| I applied BMF to front
signals and grilles, the hood center trim, rear licence plate, rocker
panel
trim and the door handles before painting. |
|
| I chose a metallic
dark blue for the new color. I applied two coats, and after each coat,
I scraped the paint on the BMF. I painted the front signals with clear
orange. |
|
| I scraped the paint
on the tail lamps and painted clear orange and red on the exposed
metal.
I applied BMF on the rear bumper and covered all with two thin clear
coats. |
|
| A bit paint and BMF
detail at the front... |
|
| ...and at the rear. |
|
| The original orange
windshield was unacceptable so I manufactured a frame for a new
windshield.
I used a 1-mm dia. brass rod. |
|
| I squared the surfaces
and the fixing parts. |
|
| Now the hardest of
them all. I wanted realistic looking headlamps, so the bulgy metal lens
imitations had to be turned to "negative". First I drilled center holes
with a 0.5 mm drill to guide the carver. |
|
| I broke apart the
headlamps from the grille and luckily, they had a small rectangular
boss
at their backs so I could fix them to a vise. I carved the reflectors
veeeery
slowly. One miss in good command would be a disaster. After they were
carved,
I covered them with BMF. |
 
|
| I sanded smooth the
breaking points of the headlamps and covered the whole thing with BMF.
I applied a flat black wash to the grille and wiped away. I painted the
licence plate flat black and scraped the letters. |
|
| I painted the windshield
frame and fixed it into place with epoxy. I cut the windshield from
acetate
and fixed it with Testors Clear Part Cement. |
|
| The door insides also
needed something scratcbuilt. I used white hard paper for the panels
and
some styrene for the armrests. |
|
| I prepared the dashboard
on the computer and glued it in place. I removed the top of the
4-spokes
and had a 3-spoke wheel. I glued the door insides and formed the "tub".
I painted the inside flat brown on the floor and flat creamish-white on
the seats. |
|
| All installed in the
car... |
|
| OK...Here are 3/4
frontal and rear views. |
 |
 |
 |
 |
| The front part is
the most standing out. I manufactured the headlamp lenses by putting
drops
of Humbrol Clear Fix in the reflectors. I repeated these droppings 3
times
after each layer was dry. |
|
| And finally, "before
and after" pictures. |
 |
|
| No,
I'm not planning to do the same to the other one! |
|
|
|
|
|
|
|
|
|
